How to Fix Mercedes w212 2011 ESC inoperative Xentry Mercedes Mb Star C4 SD Connect

Mercedes Star Diagnostic SD Connect MB Star C4 is the best diagnostic tool for Mercedes benz.  Xentry Mercedes Mb Star C4  with latest Xentry software 2017.9 and support offline and online programming. OBD2repair.com share you how to solve Mercedes w212 2011 ESC inoperative with Xentry Mercedes Mb Star C4 following.



Xentry Mercedes Mb Star C4 SD Connect 2017.9 Version With Panasonic CF-19 Ready to Use




Thread: Mercedes w212 2011 got “ESC inoperative” message, using  Xentry Mercedes Mb Star C4 to pull specific codes firstly and go on repairing, at the last paragraph, there are solution.
Car model and year:
mercedes w212 2011

Issue:
the car shows me “esc inoperative” message then the car become very heavy and it doesn’t take acceleration at all where it is stuck to 15-20 km/h..
i went to a technician and he said it is the throttle sensor, so we got it changed and everything worked fine, after two months the same problem occurred and we got the part changed again, but yesterday the problem appeared again !!

Possible reason:
ESC is electronic stability control not sure why the tech was changing out the throttle and/or position sensor.
ESC inoperative is indicating the traction control is not working. This should be able to tracked to a specific wheel sensor issue, electronic module problem or reflash needed etc.Lots of other possibilities too, steering angle sensor, yaw sensor etc.

How to do?
Take it to an Xentry Mercedes Mb Star C4 dealer and get the car scanned. They should be able to give you a specific MB code and you can go from there. Or did the mechanic scan it and come up with some codes? You can also get some aftermarket scanners, but the ones that do MB specific codes are a bit more than regular OBDII scanners which just do engine and emissions codes, not other sub systems. Your esc inoperative is one of those subsystems

These are all the messages and faults I’m getting
As you can see, I get myself a Xentry Mercedes Mb Star C4, These are all the messages and faults I’m getting.
 



* voltage of signal 1 of accelerator pedal sensor
* voltage of signal 1 of throttle valve actuator
* voltage of signal 2 of throttle valve actuator
all of these are low voltages around 0.5 where it should be a higher voltage…

Solution:
As suggested you pull codes with Xentry Mercedes Mb Star C4 DAS if steadfast on circumventing you can try OEM replacements: TVA 1131410125, ESP CU 2129005906, and OS 0035427018.
– M16/6:


– ESP control unit (N30/40) is attached to hydraulic unit, check connection pins before replacing.
– Oxygen sensor 1/bank 2 = left (driver side) front of catalyst





   



For first time Xentry Mercedes Mb Star C4 connection of the throttle valve actuator control unit carries out automatically within approx. 60 seconds the following actions:

– determines the emergency running position
– determines lower mechanical stop
– matches the actual value amplifier (signal 1 and 2) in the MESFI [ME] control unit.
– checks the return spring (always takes place when ignition ON) Prerequisite: gear P or N, vehicle stationary, engine OFF, ignition ON, coolant temperature 5 °C to 100 °C and accelerator pedal not operated.
The procedure must be activated with , if the throttle valve actuator or the ME-SFI [ME] control unit was replaced.

More detail about Xentry Mercedes Mb Star C4,pls connect


Website:www.obd2repair.com
Skype：obd2repair / eobdscan1
Whatsapp (+86)13728823163
Email: info@obd2repair.com